Installation Instructions




COMPONENTS
  1. Template (double sided)
  2. Lock Assembly
  3. Lock Key
  4. Striking Plate
  5. Drill Bit Depth Gauge
  6. Extension Slug
  7. Plunger
  8. Screws: #4 x 1/2” Pan Head Phillips
  9. Unlocking Bar

TOOLS REQUIRED
  1. Power Drill
  2. Phillips Screwdriver
  3. Punch or Nail
  4. 1-Drill Bit 9/32” (7mm)
  5. D1-Drill Bit 1/16” (1.5mm Optional for pilot holes)
INSTALLATION OVERVIEW
DOOR THICKNESS
Use components within arrows.

USING KEY
Use Lock Key to open cabinet door/drawer.
.
STEP 1
Peel narrow backing paper strip from Template’s Lock Assembly side, flip over. Apply that side to cabinet frame, the Template’s Striking Plate side is facing out.

STEP 2


Peel backing, close cabinet door firmly, transferring template. The template will now display the Lock Assembly icon.
STEP 3
Open door and mark + with punch.

STEP 4
Measure door thickness and subtract 3/16” (4.76mm) to obtain drilling depth.
STEP 5

Drill into the marked 9/32” hole location into installation template, using caution not to drill through the door. The hole must be clear and free of debris.
STEP 6

Match striking plate over two locations marked during Step 2. Use screws and install loosely so slot adjustments can be made later.
STEP 7

Install red unlocking bar in hole on one side with unlock letters up. Then straddle the housing and pop in the opposite side.

Match the Lock Assembly with plunger to the drilled hole. Align with marked holes, secure with 1/2 inch screws.